Can Present Sensor with Quick Connect NAQ3000-N03 This rail mounts to the

This rail mounts to the exit end of the machine and is used to guide cans out Rinse Tunnel

Bore Size: 125mm

Ergonomic design requires no physical pressure to operate and eases stress on the hands and wrists

This Lid Top Guide is made of HDPE and is found on all standard Lid Droppers set up to run 202 diameter lids

A 13mm wrench can be placed on the flat sides of the standoff to help tighten it down

Can Present Sensor with Quick Connect NAQ3000-N03 This rail mounts to theThe can present sensor is used on all EVO and WG8 10 systems and comes with an assembled 3 wire quick connect Commonly referred to as "First and Last can sensors", this inductive proximity sensor is used to detect the presence of a can at the first fill head and last CO2 purge tube. An additional can present sensor is found near the seamer's entrance. A can must be present at these sensors for the filling seaming cycles to start.